top of page
Performance Friction
Follow the instructions below for bedding in your Performance Friction pads
-
Tape up ducts ½ - ¾. Make several slow stops to ensure sufficient pad/disc contact area (typically 80%).
-
Do not left foot brake. Do not drag brakes. Make several firm/hard stops from as high a speed as possible. These stops should be made early, as all pads will exhibit fade until fully conditioned. On light braking circuits extra stops on long straights can be made to speed bedding process. Continue procedure until fade is no longer apparent.
-
Important - make 1 or 2 cooling laps without using brakes.
-
Check temperature paints - discs must have reached peak operating temperatures to be sure of full bedding. Remove tape as required.
bottom of page